2 PIECE TOOL KIT HK416 417 MR HAUS 🇺🇸

$29.60

Translator

 

 

In stock

Add to WishlistAdd to Compare

Translator

 

HAUS two piece tool kit includes one piston rod guide bushing tool and one handguard locking bolt driver bit.
HAUS piston rod guide bushing tool.

This tool is designed to hold center so it won’t slip when you’re using it and it’s magnetic so it won’t fall out of your bit driver.

Material – Heat treated 17-4 stainless steel

Finish – Non – reflective matte

Compatibility – For use with Genuine Heckler & Koch and HAUS brand bushings for HK416, HK417 and MR Series rifles.

🇺🇸 Made in USA

  • When installing a bushing apply a drop of Rocksett or high temperature Loctite and snug it up, do not over tighten your bushing, there is no need to exceed 15 inch pounds of torque.

WARNING! IF YOU INTEND TO USE THIS TOOL TO REMOVE A BUSHING FROM A FACTORY HK UPPER RECEIVER BE AWARE THAT THE BUSHINGS ARE INSTALLED BY HK USING A “ROCKSETT LIKE” PRODUCT AND YOU RISK DAMAGING YOUR BUSHING AND YOUR TOOL IF YOU DO NOT TAKE STEPS TO DISSOLVE THE FACTORY INSTALLED THREAD LOCKER BEFORE ATTEMPTING TO REMOVE A BUSHING WITH THIS TOOL.

HAUS handguard locking bolt driver bit.

This bit was designed specifically to fit the inner “plus sign” feature in the original HK416 and HK417 handguard locking bolt.

Drive compatibility – 1/4″ bit driver

Length – 1.25″

Material – These bits are made from heat treated 17-4 stainless steel and they’re magnetic so they won’t fall out of your bit driver.

Compatibility – Genuine Heckler & Koch handguards for early model HK416, HK417 and all Geissele SMR HK handguards.

Finish – Non-reflective matte finish.

  • Bits only, bolt is not included.

🇺🇸 Made In USA