PISTON ROD GUIDE BUSHING INSTALLATION BIT HK416 417 MR SERIES HAUS 🇺🇸

$24.00

In stock

Add to WishlistAdd to Compare
HAUS piston rod guide bushing assembly tool.

This tool is designed to hold center so it won’t slip when you’re using it and it’s magnetic so it won’t fall out of your bit driver.

Material – Heat treated 17-4 stainless steel

Finish – Non – reflective matte

Compatibility – For use with Genuine Heckler & Koch and HAUS brand bushings for HK416, HK417 and MR Series rifles.

Drive size – 1/4″

🇺🇸 Made in USA

  • When installing a bushing apply a drop of Rocksett or high temperature Loctite and snug it up, do not over tighten your bushing, there is no need to exceed 15 inch pounds of torque.

WARNING! IF YOU INTEND TO USE THIS TOOL TO REMOVE A BUSHING FROM A FACTORY HK UPPER RECEIVER BE AWARE THAT THE BUSHINGS ARE INSTALLED BY HK USING A “ROCKSETT LIKE” PRODUCT AND YOU RISK DAMAGING YOUR BUSHING AND YOUR TOOL IF YOU DO NOT TAKE STEPS TO DISSOLVE THE FACTORY INSTALLED THREAD LOCKER BEFORE ATTEMPTING TO REMOVE A BUSHING WITH THIS TOOL.